Pro-tools EMN-510 Manuel d'utilisateur télécharger pdf (Page 8)

QUALITY PRODUCTS MADE BY PEOPLE WHO CARE PRO-TOOLS (813) 986-9000

PAGE 8

GODZILLA

END MILL NOTCHER

INSTRUCTIONS:

• WEAR SAFETY GLASSES OR SAFETY SHIELD.

•TURN MOTOR AND END MILL WHEEL (A) UNTIL THE END MILL IS FARTHEST FROM THE VISE.

•LOOSEN BOLTS (B) SECURING THE SWIVEL BASE TO OBTAIN THE DESIRED ANGLE FOR YOUR

PARTICULAR JOB. MAKE SURE YOU RE-TIGHTEN THE BOLTS!!

•OPEN VISE WITH MATERIAL VISE HANDLE (C) AND SECURELY CLAMP MATERIAL TO BE MACHINED.

DO NOT EXTEND MATERIAL ANY MORE THAN NECESSARY OR CHAFFING MAY OCCUR.

•BRING THE CUTTER CLOSE TO THE MATERIAL (BUT NOT TOUCHING) BY TURNING THE MOTOR

AND END MILL INTO THE MIDDLE AREA OF THE CUTTER. WARNING: NEVER NOTCH USING THE

END OF THE CUTTER.

•SWITCH THE MOTOR ON AND TURN THE MOTOR AND END MILL WHEEL (A) BRINGING THE END

MILL INTO THE MATERIAL TO BE MACHINED.

•AFTER DESIRED NOTCH HAS BEEN ACHIEVED, SEPARATE THE CUTTER FROM THE MATERIAL,

TURN OFF THE MOTOR AND RETURN THE END MILL TO THE FARTHEST POSITION AWAY FROM

YOUR MATERIAL.

•DO NOT FORGET TO CLEAN MACHINE WITH WD-40 WHEN FINISHED.

MATERIAL CLAMP (C)

MATERIAL CLAMP WHEEL (D)

BOLTS SECURING

SWIVEL BASE (B)

MOTOR AND END

MILL WHEEL (A)

WARNING: DO NOT REMOVE

LEXAN SAFETY SHIELD. IF BROKEN,

DO NOT OPERATE MACHINE.

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Pro-tools EMN-510 Manuel d'utilisateur Page 8